Hatsan gauge

[SH95503]

I recently bought a used Hatsan Flash Wood in 25 cal. After total reseal, deburring, grinding and polishing off sharp edges, I now have a gun that I can disassemble and reassemble without cutting 'o' rings and a bolt that slides very good. I installed a Huma-Air regulator set at 160 bar and a bi-pod. After testing several different pellets I have found two types that I can shoot 1/2 inch groups at 50 yards, I believe that is good enough for hunting birds an small game. I do have one question I hope someone can answer, after installing the Huma regulator the gauge on the gun will not go to 200 bars is this gauge now regulator pressure or still fill pressure.

Thank You 

Hank

 

[doni]

It's the regulator pressure now, because the regulator is before the gauge.

 

[SH95503]

Thank you doni, I figured as much but I'm new to pcp,s and wanted to hear ir from a more experienced person.

 

[SH95503]

Thank you Bruce54, for your very informational replay. I learned a lot from your reply that I didn't know very helpful. New to the pcp's and learning a lot, love the way they shoot over a break barrel and the pumps.

 

[Bruce54]

Hank, you are welcome! The world of pcp's is a real adventure and very satisfying. You will surely run into many more questions but you are at the right place to find the answers you may need. A lot of very informed people haunt these pages and are always willing to help out. Welcome to the forum!

Bruce

 

[KatoKevin454]

I believe a Hatsan cylinder end Gauge will fit the existing cylinder, not exactly sure, but you could call Hatsan USA and find out. if it does the you can have 2 gauges, cylinder pressure and regulator pressure.

 

[SH95503]

Thank you KatoKevin454, I was wandering about that last night. I will give them a call today and see if that is possible. I know they make one for the Diana Stormrider. Happy shooting.