You should not need to filter air from you bottle. It should be dry. If it isn't, you are damaging your bottle (the liner is aluminum).
Upvote 0
Gx filter is here
- Thread starter 1900colt
- Start date
If you fill tanks then I suggest to rig the filter so it's above the compressor. I have my non GX filter rigged on a stand so the GX hose runs up to the filter inlet to promote any condensate to drain back to the compressor's water trap. I feel that it limits the amount of moisture that goes into the filter. Then tank is above the filter outlet.
For gun fills I think sticking the filter on the compressor is probably fine, but note GX's recommendation to not put the magnets next to the power supplies (for the CS3-I and CS4-I).
For gun fills I think sticking the filter on the compressor is probably fine, but note GX's recommendation to not put the magnets next to the power supplies (for the CS3-I and CS4-I).
Upvote 0
I haven't acutally tested it yet, was just trying to see where I could stick the filter. I don't like where it is currently. I also read about not putting the magnets on the case next to the inverter. Probably will build a little cart for the compressor with the compressor on the bottom and the filter above it. I will say the filter feels really well built.
Upvote 0