Somehow I lost the black rubber disc in the grease pot!!! In ideas where to order a new one?
Thanks
Thanks
GX CS4 compressor grease pot
- Thread starter Powerstroke
- Start date
Is this the part you are looking for? https://gxpumpofficial.com/collecti...lack-diaphragm-rubber-disc-for-cs4-grease-pot
Please share how you lost the original.
Please share how you lost the original.
Upvote 0
That's the part... I was adding grease and just cleaning the pot etc. While I was fishing out the disc...POOF! Instantly disappeared, cannot find it anywhere?
Upvote 0
I measured the thickness of the messed up one I had and ordered the same thickness black rubber sheet from amazon. Then you just put the rubber on a flat surface, put the grease pot on top on the rubber and smack it with a rubber mallet. The cookie cutter method gives a perfect replacement piece. Then take a tiny drill bit or heated large sewing needle and make the center hole. Works just fine and lots of rubber to do it again if I have to. Plus it's cheaper than buying the part from GX. Make sure the screw is fully into the pot by screwing it clockwise to keep the little screw from being hurt by the mallet. You can also just put the grease pot on top of the rubber and twist it until it starts to leave a cut in the rubber and just cut it out following the cut you made with either a exacto or scissors.
Last edited:
Upvote 0
Send me a private message with your information. I made a handful of them up for myself and another member. I got an extra few, you can have one.
Mike
Mike
Upvote 0
I was just thinking the other day. What is under the grease pot ? How does it get into the cylinder? I was thinking could you just take the grease out and at service interval take the grease pot out and have access to just manually add grease to the cylinder thus having much more control over the amount ?
Upvote 0
If you have a 3d printer that can print TPU then...
www.airgunnation.com
gx cs4 rubber diaphragm
IMO you shouldn't over tighten the grease pot or it may damage the rubber diaphragm. I was careful then I removed the pot, adjust the grease level and reinstalled the pot. I only tighten it until I felt the pot hit the diaphragm. But later I forgot and turned the pot's body down until it reached...
www.airgunnation.com Upvote 0
New question regarding the new rubber diaphragm that I purchased from GX. It does not have a hole in the middle, does it supposed to have one?
Upvote 0
