Went to charge a gun today check to make sure bleed valve open, cut ac power on came on for a couple seconds cut off and now I get nothing.
- The AGN App is ready! To compliment this new tech we've assigned the "Threads" Feed & "Dark" Mode. To revert back click HERE.
GS-e-cs4-i issues
- Thread starter Baldone
- Start date
Have you tried turning it off for 30 seconds and turning it on again?
What about using 12vdc instead of AC?
Upvote 0
So what gives? I decided to try it again this morning and it worked as it should. What did I do ?
Upvote 0
Just a WAG, but I suspect the internal PS is a tad more sensitive to loads. Have had this happen with mine twice. Shut it off, wait 30 seconds, and it starts right up.
Upvote 0
This thing is acting funny again. Filled gun this morning to 290 bar from 100 bar. This evening it won't go above 150 bar. So tried the gun with same fill probe off tank works fine. Put dead head in just hose without filter and same issue. I can't hear air leaking from anywhere.
Upvote 0
Check your burst disc (don't over-tighten it when re-installing) and then check your bleed valve.
Upvote 0
Look down inside the quick disconnects. GX has two o-ring stacked up in there. Mine had a green o-ring on top of a black o-ring. The green o-ring was for poop
Upvote 0
I got mine from ace hardware which is local to me. 79 cents each. Use a pick of some type and pop the o-rings out. Slide the new ones in.
Upvote 0
A blown disc. Or a lot of grease in the orifice. If dirty, clean it and re-install. If blown, clean the orifice and replace with one from the kit that came with the compressor.
Upvote 0