I have two GK1, both will fill to 32 mpa then slow leak to to around 30 mpa in a few minutes sometimes 28-29 but not often, where should I look first? Or is this something I should just live with?
N/A GK1 slow leak
- Thread starter rcrawford58
- Start date
does it stop?
i'd imagine it's just the standard post high pressure fill temperature settling.
i'd imagine it's just the standard post high pressure fill temperature settling.
Upvote 0
Every single gun I have does that. Forcing an incredible amount or air into a confined space generates energy in the form of heat, which causes a slight increase the amount of space air molecules take up. The energy is slowly released through the tank or cylinder as it radiates heat and the air slightly decreases in volume. You have less pressure.
Fill slower or top off when the cylinder cools.
Last edited:
Upvote 0
The smaller the pressure vessel, the more aaparrent thermal changes tend to become. Let it settle and watch it for a week. If it stays where it settled you have your scientific conclusion.
Upvote 0
@rcrawford58 Do you top off your GK1 fast or slowly? What do you use to fill your GK1s? Have you felt the temperature of the carbon fiber around your reservoir directly after topping it off? If so, how does it feel?
Upvote 0
When I start to fill the Gk1 the mpa is at about 14-15, it then fills in about five minutes. I haven’t checked the reservoir temperature but will the next time I fill and get back to you.
Upvote 0
@rcrawford58 What do you use to fill it? A hand pump. SCBA tank, or compressor? Which pressure do you normally your GK1 to?
Upvote 0