@dairyboy Yes, holding same. However, at 28 yards a PCP should not be that hold sensitive. For that I can save a lot of money and frustrations and only shoot Springers.
@hussn32 Indeed. I keep asking @fx_usa about the "Superior" liners, they are supposed to come out in .177 at some point, but I've yet to hear from them.
@tor47 Barrel has been cleaned & polished. I don't have to clean my Crickets this much, ever. I know there are guys out there that never clean their FX liners and their guns shoot well, or so they say. As for the different kind of pellets, it doesn't seem to matter what I do. I shoot 8 shots of the JSB Monsters into a single hole, test again in a little while, same POI, test again and it has gone to hell with no explanation whatsoever.
@bubblerboy64 Have verified the scope is not the problem. I have changed the scope a couple of times. I have also shot the original scopes that came off the WC in the other guns and the other guns are shooting perfectly.
@rj I can tell you that there is no o-ring in there. I looked. Will look for the size and see if I can source from somewhere and install. Hope that is the problem. Pellet probe is spot on. Have meticulously measured each time I take gun apart. All screws are on tight.
Thanks to all again.
@hussn32 Indeed. I keep asking @fx_usa about the "Superior" liners, they are supposed to come out in .177 at some point, but I've yet to hear from them.
@tor47 Barrel has been cleaned & polished. I don't have to clean my Crickets this much, ever. I know there are guys out there that never clean their FX liners and their guns shoot well, or so they say. As for the different kind of pellets, it doesn't seem to matter what I do. I shoot 8 shots of the JSB Monsters into a single hole, test again in a little while, same POI, test again and it has gone to hell with no explanation whatsoever.
@bubblerboy64 Have verified the scope is not the problem. I have changed the scope a couple of times. I have also shot the original scopes that came off the WC in the other guns and the other guns are shooting perfectly.
@rj I can tell you that there is no o-ring in there. I looked. Will look for the size and see if I can source from somewhere and install. Hope that is the problem. Pellet probe is spot on. Have meticulously measured each time I take gun apart. All screws are on tight.
Thanks to all again.
Upvote 0