FX MK2 cocking block side lever pin.

[cosmic]

Does the side lever cocking pin press into the cocking block ? I tried to call.. They sent me a new block with everything EXCEPT the pin for the cocking lever.. First I bent the pin so I had to buy a new cocking block ,but that one is rough cocking, the one they sent that I just picked up and that one does not have the pin for the cocking lever. Even the hole for it is not drilled all the way through..
Ideas ?

 

[cosmic]

They want the old one back before they send a new one !! Which out of the three do I send.. I guess it doesn't matter since this the last day I can shoot...

 

[Airgunmann]

I don't think they want anything back just forgot to send the pin email fx and tell them what you need they will help you

 

[Bigragu]

If you look at the parts schematic the pin is an itemized part. You can’t order a block and have the pin come with it, or even the rubber ball. I think the hockey puck slider discs are the only parts that accompany the block. If it were me I’d order 3 each of the pins made for an impact so you have spares-
Cocking block pins
Trigger housing pins
Pellet probe holder block pins

 

[bigHUN]

In my case the two pins/holes were not same size. The upgraded to ST ambidextrous blocks, same thing. I re-drilled myself and did a pin DIY from a shoulder screw, cannot remember was that a 3mm on equivalent in imp.
The original pin was soft anyway but finally learned not to trigger when the handle is not closed.

 

[cosmic]

I figured it out without FX help since they were closing early, I guess the tech couldn't take 2 minute to talk to me.. The pin that was missing is for the cocking lever attachment..
If you tighten the cocking rod until it stops it distorts the back, 2 big puck at the top of the block ( the back one)since the hole for the rod goes all the way through.. So I have 3 now, the one with the bent pin, the one they sent without the cocking lever pin, and the new one..