fx impact
- Thread starter Airgunmann
- Start date
It's a 22 my plan is to shoot 18 gr pellets for now till I get my hand on more 25gr jsb pellets and I might also try 25 gr knockouts later down the road
Upvote 0
The Knockouts kicks butt for a commercially made slug. Get them all while their dies are still new.
Upvote 0
I think it is. Upgrading to the dual transfer port and the pin probe increased speed by 50fps. I have made no other mods to my new Impact and out of a .22 600mm barrel I’m shooting 27gr H&N slugs at 960fps with the reg on 125 bar.
Upvote 0
I shot my impact today it's quiet with the donny fl upgrade and it is really smooth . Shot a few over the chrono it's got more extreme spread than I like but I'm going to shoot it some more before I tune it . I only put one mag threw it so far
Upvote 0
Shoot it for a bit, like several mags worth to let everything take a set and wind up where it's going to be.
Then, if you can not resist, begin to tweak things to get it where YOU want it to be if the factory set up is not cutting it.
I have the exact same set up and it is super sweet.
125 bar sending Hybrids at 900 FPS for 60 shots give or take. I usually just refill it after 2 full mags and call it good.
Then, if you can not resist, begin to tweak things to get it where YOU want it to be if the factory set up is not cutting it.
I have the exact same set up and it is super sweet.
125 bar sending Hybrids at 900 FPS for 60 shots give or take. I usually just refill it after 2 full mags and call it good.
Upvote 0