Hi all,
I've recently purchased an Impact, and i'd like to shoot it at 12fpe. Is there an optimal pressure to set the regulator at for this power level? It came from factory set at 150bar, and i've since lowered it to 105 bar, but it made very little change to the chrony numbers. That is, i could achieve 12fpe at 150bar, and still could at 105bar, but i think i might be "choking" it too much. The instructions explicitly say not to lower the reg pressure below 100bar, but there is a side note that says the UK spec (12fpe) settings are different.
Any help would be appreciated,
Thanks!
Ryan
I've recently purchased an Impact, and i'd like to shoot it at 12fpe. Is there an optimal pressure to set the regulator at for this power level? It came from factory set at 150bar, and i've since lowered it to 105 bar, but it made very little change to the chrony numbers. That is, i could achieve 12fpe at 150bar, and still could at 105bar, but i think i might be "choking" it too much. The instructions explicitly say not to lower the reg pressure below 100bar, but there is a side note that says the UK spec (12fpe) settings are different.
Any help would be appreciated,
Thanks!
Ryan