Tuning FX Impact Mark II Gauge Replacement Procedure Information Sekhmet Gauges

[Synthetic]

I'm new here so I may not be in the correct thread for this but need some help/

First question: Is there a specific Topic Thread specifically for the FX Impact? (I looked but could not find)

2nd question: Looking for information on the correct way to replace the factory air gauges.

I bought two Sekhmet Digital Air Pressure gauges to replace the factory tank and regulator gauges on my Impact Mark II

I have searched online at several sites but have not been able to find the correct procedure. Since my Impact is new to me I sure don't want to mess it up.

Appreciate any help with this.

Thanks in advance...

 

[Glem.Chally]

Take the bottle off slowly until it starts to hiss, once it feels like it loosened up then remove it. Go slowly you'll feel when it starts to bleed, let it bleed the gun off before removing too far.

Do the same with the gauge on the side of the gun. ( this one will probably have no pressure behind it once you remove the bottle )

Do the same with the gauge for the reg. Go slow.

When installing just tighten by hand until it bottoms out then back it off until its oriented correctly. The air pressure will seal them. 

Heres some tips on setup and usage. 





https://youtu.be/rMfC0IG09RI

 

[gendoc]

you tha man Glem.......

 

[Synthetic]

 .

 

[Synthetic]

 

Thank you Glem...

 

[Healthservices]

The key is hand tight, do not tighten to the point the o-ring distorts or tears. The o-ring does the sealing. As soon as the air pressure is in, the guage will be tight.

 

[Cjjr2318]

I just bought a sekhmet digital gauge for my M3. Inside the box is a metal with rubber in the middle o-ring. I'm mounting it into an FX angled bracket. All of the videos I've watched don't mention installing it. Should i?

Thanks for any help in this matter.

 

[Glem.Chally]

Sounds like a dowdy seal, I'd try it. 

 

[cosmic]

 There should be a X shaped o ring for the gauge

 

[JoelCG]

Hi Sintetic, i bought an MK2 but i install it the dual stage tuning regulator (Huma-Air), so now i have two regulation stage (like M3) , do you know what of the two manometers i have to change to use the stadistics tools of the sekhmet (average consum etc), the first (next to the tank) or the second (plenum pressure)??

Regards!!

Joel CG