Fx impact barrel guide

[spyde82]

Anyone know where i can get a barrel guide ( A13) for the impact?



so i have a lot of barrel flexing and i tryed to put some tape around the barrel where the A13 barrel guide is and it seemed to help, so the plan is to get a new barrel guide and make the hole big enogh so that i can make delrin bushing that sits on the barrel.



more testing needed.

 

[biohazardman]

 

Call or e-mail them to get parts.



FX Airguns USA

3024 Hall Watters Dr Suite 106

Wilmington, NC 28405

Phone: +1 866 639 0772

[email protected]



I have heard just using some duro 90 0-rings there will help greatly but have never had a problem so never got around to that yet.

 

[Glem.Chally]

Maybe Bagnall and Kirkwood airgun spares. I dont think fxusa ships out of country anymore.

 

[Jlands]

I personally think over tightening is the primary problem. I haven't done testing, but i know "tight" is subjective. One person's snug could be another person's damn near stripped and everything in between. This first crossed my mind when I did my initial out the box cleaning. I used a drop of blue loctite and just "touched" (again, touch is subjective) the liner.



I use factory O-rings and placement. No problems.