FX fx dreamline wont fire

[jaylox]

2023 fx dresmline lite/tactical

hi guy was at the range and halfway through my session my rifle jyst stopped working
i thought i must of been low on air
BUT
MY bottle was 2/3rds full and my reg at 90
rifle just fires like im out of air
has an o ring blown
ive checked the bottle and regulator and everything is fine
any advice appreciated

its a new model gen3 reg

i had just swapped over from .25 down to .22 barrel and pin when it stoped half hour later
cheers jay

 

[wildcj5]

Silly question. Did you check you had tightened the barrel? Possibly you didn’t and to rotated the transfer port to the point of not lining up.

I had a buddy rebuild one of his guns and then couldn’t get it to fire. I took it apart and he had somehow installed the barrel wi the tp hole off by 90 degrees.

 

[jaylox]

yes

 

[greenbeans]

Breech oring?! Load a pellet without the magazine in and put a tissue over the beech. Take a shot, if the tissue goes flying oring is bad. Could also be barrel orings.

I’ve also seen the TP not being perfectly aligned so that if you you turn the adjuster the ports don’t align properly, resulting in inconsistency and obviously low power.

 

[cahil_2]

Pellet stuck in barrel?

 

[greenbeans]

Wait, when you say “fires as if I’m out of air”, do you mean just clicking the hammer but nothing happens? Not even a little air?! If so, then hammer is obviously not opening the valve since your reg/plenum gauge is reading pressure. Could be a bent/broken valve pin then or something blocking the hammer.