Does anyone make an upgraded valve seat, ie. a heavier duty one, for the Dreamline? Been looking but haven’t found one yet.
Upvote 0
FX Dreamline valve seat
- Thread starter wimpanzee
- Start date
Dumb question: does that occur when people crank up regulator pressure to 160+ bar, the HST to its maximum, and then dry fire once in a while? Every time people do that, the valve strikes the valve seat so hard that it could get damaged over time... Make sense?
Upvote 0
its not stupid question, i have not dry fire my dreamline and still not a single valve seat last more than 300 shots. All i did was raised hammer spring tension with 2mm washer because FX lied about power of this gun. Without washer sure valve set could last longer but the gun is weak on default hammer spring tension, not near declared 60 joules
Upvote 0
Anyone know if this pertains to the brand new Dreamline's or is this a problem with the older ones
Upvote 0
It's a problem for the old ones. I had my "first gen" Dreamline Crack a valve seat and I replaced it with the 910 Titanium one. Good ever since!
Upvote 0
My Dream tac Compact that i bought in 2021 has leaked out all its air & i cannot fix it even after replacing the Valve pin & seat including the O rings.
Today i found that the Valve pin that Bagnell & Kirkwood sent me has a smaller dia delrin poppet than my factory Valve pin
Today i found that the Valve pin that Bagnell & Kirkwood sent me has a smaller dia delrin poppet than my factory Valve pin
Upvote 0