i have several 10mm belleville washers that are different heights,(.002 - .005) does anyone know if that would effect or cause inconsistent fps.? have both fx & huma. i have it below 10 but looking better..tks.
FX Crown 10mm belleville washer ..?
- Thread starter allenbowles
- Start date
I have my doubts it would cause any inconsistencies but it will lower or raise your reg pressure slightly. Huma stated, in one of their instruction sheets, that one can add a washer from the FX reg, which is a different thickness than the huma regs washers, to their stack to increase the maximum regulator pressure if needed.
Upvote 0