Fx compacts

Id like the fx crown mk2 with 380mm barrel


that’s what I really want also!!! Haven’t found anyone that would sell one yet.

HAHA, I think the barrel would be up inside the receiver. Don't the compacts come with a 500mm? and the barrel is crazy short on them.

I shortened this on a picture editor BTW lol



Untitled.1609695546.png

 
Id like the fx crown mk2 with 380mm barrel


that’s what I really want also!!! Haven’t found anyone that would sell one yet.

HAHA, I think the barrel would be up inside the receiver. Don't the compacts come with a 500mm? and the barrel is crazy short on them.

I shortened this on a picture editor BTW lol



Untitled.1609695546.png


I would like to have the 380mm on the crown, not the impact! LOL 



Utah airgun already has one I just cannot justify the 2k for it especially when it’s not a MK2.

EC3350F9-F99A-418E-9C5A-9E5B0BFC1362.1609714845.jpeg

 
Hmmm, yeah, I don't think I like the look of that Crown. Maybe just the scope looks too big



Cool they've got one, though. I bet it's silly light. I think mine with synthetic stock, and no scope (380mm barrel) was 6.5lbs on the nose



Also, that looks like a 320mm barrel.





Yes, that's the 177 barrel which is 320mm. You know what I really want after looking at all the compacts? FX put the wildcat action in a rifle chassis so it's a semi bullpup with foldable rear stock.......that would be crazy sick and short(ok, couple of inches)!!!! @FXAirguns! Did you hear that? Do I get a free one for coming up with this idea? LOL
 
I tried shooting the 500mm with the DonnyFL Tanto and no shroud. It was LOUD, probably going to be even louder with the 380mm and a small suppressor.

You'd be surprised. I use a tiny huma mod on mine, and it is near silent on low power. I also installed a baffle inside my shroud to reduce the exit from 9.5mm down to 6.2mm

On high power, it isnt horribly quiet, but still very considering how loud it would be otherwise.

Also, tune has a lot to do with loudness 

DSCF5589_edited.1609753723.jpg

 
I tried shooting the 500mm with the DonnyFL Tanto and no shroud. It was LOUD, probably going to be even louder with the 380mm and a small suppressor.

You'd be surprised. I use a tiny huma mod on mine, and it is near silent on low power. I also installed a baffle inside my shroud to reduce the exit from 9.5mm down to 6.2mm

On high power, it isnt horribly quiet, but still very considering how loud it would be otherwise.

Also, tune has a lot to do with loudness 

DSCF5589_edited.1609753723.jpg

I agree, with a decent length shroud the noise is minimum. There won’t be much of a shroud if you install a 380mm barrel on the impact. The barrel only extend a few inches pass the barrel support block. 
 
I tried shooting the 500mm with the DonnyFL Tanto and no shroud. It was LOUD, probably going to be even louder with the 380mm and a small suppressor.

I agree, with a decent length shroud the noise is minimum. There won’t be much of a shroud if you install a 380mm barrel on the impact. The barrel only extend a few inches pass the barrel support block.

Well, the superlight barrels have no air strippers like older crown and impact barrels. With the 9.5mm exit hole, they can still be quite loud. Thats why I reduced the exit