I have a regulator leak on a maverick.
I think I can fix this, but, would someone give me an address of where I can get an O ring kit?
I think I can fix this, but, would someone give me an address of where I can get an O ring kit?
FX AMP REG
- Thread starter DonaAna1
- Start date
Call Utah Air during RMAC. That my friend is an exercise in futility.
Maybe next week. The good thing is I have a couple of other guns, so I do have time to wait,
Thanks for the info, I looked all over their website and couldn't find kits.
Maybe next week. The good thing is I have a couple of other guns, so I do have time to wait,
Thanks for the info, I looked all over their website and couldn't find kits.
Upvote 0
If your gun is not too old call FX USA.
Word of warning those little tiny O-rings on the regulator stem are no fun to replace. Make sure you are on a surface that wont allow the little buggers to bounce and will keep them visible when you lose your grip on them.
I have done it twice and it ain’t good entertainment. I like a white bath towel For a work surface.
Word of warning those little tiny O-rings on the regulator stem are no fun to replace. Make sure you are on a surface that wont allow the little buggers to bounce and will keep them visible when you lose your grip on them.
I have done it twice and it ain’t good entertainment. I like a white bath towel For a work surface.
Upvote 0
you could go to 910 airguns Newman sells the o ring kits i got few o rings what are you looking for PM ME
Upvote 0
Called FX, low and behold, after RMAC there were some technicians there.
The maverick is still under warranty and even though the leak was my fault, they are sending the o rings.
But, I will need to install the little buggers. I think the end of a mechanical pencil may work easy peasy. I'll find out for sure.
The maverick is still under warranty and even though the leak was my fault, they are sending the o rings.
But, I will need to install the little buggers. I think the end of a mechanical pencil may work easy peasy. I'll find out for sure.
Upvote 0
LUBE THEM UP GOOD hopefully they send ya few extra of the ones on the reg adjuster they can be a pain but once you do them its easy great tip is to polish the washers with 3m paper i did my impact stuff all up to 22,000 paper grit never had any creep to begun with but like my stuff poished up
Upvote 0