Fix your spinner target from "walking"

[bdzjlz]

Almost every single blade manufactured spinning target has a some form of raised spot on either side of the spinner blade, that eventually wears, and allows the blade to slip off center, and/or get stuck.

See the simple fix below - cut a small section of 1/4" plastic tubing to use as a spacer, then use 1/4" ratchet hose clamps over the plastic tubing. This is a five minute fix and the target will now last until you finally shoot the blade totally up beyond repair.

Have fun!

 

[crittahitta]

Nice fix. thanks. I have that spinner and it gets stuck too.

 

[Stefanjan]

Ok whats the solution for that cheap Allen taget from walmart The spinners either wont set on the reset arm or if i bungie the arm it wont allow them to drop. Love shooting it but just cant seem to get it working correctly. Oh nice fix on that. I was wondering what happens when those tabs wear out. 

 

[fishinwrench]

I just used a couple zip-ties.