Hello, I have an Edgun Matador, I suppose from the first series (#1862), and I am looking to replace the firing valve. I would appreciate any information on where I can buy it.
EDgun Edgun Matador problem
- Thread starter cannonata
- Start date
There's an Edgun dealer out of Spain I don't remember the website name. Might have a better chance of getting parts from him than Edgun West. Especially if you have a R3/R3M.
Upvote 0
The problem is that being one of the first models, there is not much information on the web. I've had it for over 10 years and I've never had it serviced. After doing it a few days ago, and not having found anything wrong, I put it back together and found that the release valve is leaking and does not raise pressure. I suppose that the Teflon seat, after all these years, was marked and when I put it back together the position does not match. What a bad idea I had. I really didn't think it would be that difficult to find the replacement. Thank you
Upvote 0
Upvote 0
Other parts available for that rifle as well.
www.edgun.shop
New Steam Valve for R3 and R3M - KL100220
www.edgun.shop Upvote 0
Other parts available for that rifle as well.
New Steam Valve for R3 and R3M - KL100220
Other parts available for that rifle as well.
New Steam Valve for R3 and R3M - KL100220
Thanks for the information, I'll try asking tomorrow. Compared to the one in the photo, mine measures 58.55mm for the metal part and 50.31mm for the Teflon part.Other parts available for that rifle as well.
New Steam Valve for R3 and R3M - KL100220
Upvote 0