Dream tac compact .25
- Thread starter cfs916
- Start date
I would probably ruin those parts if I tried that. A Dremel tool and I are a destructive force not to be reckoned with. I gave all my Dremel tools to my son n laws , I just could not afford to keep them, LOL.
After reading some of those post you included , maybe somebody can make a "power kit" for it. I have not moved my Huma reg above 150 yet. I did get the extra high pressure reg for it, I have lots of room there. That might open up a whole new can of worm for this tiny platform. Also have a couple higher settings on the HS before I max that out. It is good now, however I always like to the see the full potential of a machine.
https://www.huma-air.com/FX-Dreamline-Regulator-(Bottle-version)
After reading some of those post you included , maybe somebody can make a "power kit" for it. I have not moved my Huma reg above 150 yet. I did get the extra high pressure reg for it, I have lots of room there. That might open up a whole new can of worm for this tiny platform. Also have a couple higher settings on the HS before I max that out. It is good now, however I always like to the see the full potential of a machine.
https://www.huma-air.com/FX-Dreamline-Regulator-(Bottle-version)
Upvote 0
Update with my .25 Dreamtact Compact
Reg at 140bar 16 shots per fill
Barrel inlet and pellet probe elongated
JSB 25gr 850-855fps
RS slug 26gr 835-840fps
Reg at 140bar 16 shots per fill
Barrel inlet and pellet probe elongated
JSB 25gr 850-855fps
RS slug 26gr 835-840fps
Upvote 0
That is excellent fps, the .22s are not doing much better than that. Not the best shot count.
Upvote 0
Is the brass barrel inlet left hand threads & or right? Has anyone replaced one and I guess it might have Loctite applied? Before I screw one up I want to make sure I can easily replace it.
Upvote 0
Right hand thread. You will need to apply a bit of heat to remove it. Also used red loctite when reinstalling.
Upvote 0