Looking for an assist. I have a Diana gas-piston rifle AMO3. Recently after cocking the rifle and closing the breach the rifle will discharge without a trigger press. Any guidance would be appreciated. I'm mechanically inclined and do maintenance on firearms, but never disassembled an air rifle. I think I paid $350 through Pyramid a few years back and do't know if it's worth sending off to get fixed.
Diana Diana AMO3 Gas-Piston air rifle.
- Thread starter dannyboy0496
- Start date
The AoA website says it has a T06 installed but I have a sneaking suspicion thats its slightly different than a coil spring guns T06. Off the top of my head, at least until someone smarter than me shows up, I would definitely start with YouTube University
Upvote 0
Ya, trigger adjustment too fine and no shear engagement a good start ..
Also this spring could be broken
Part # 131
Honestly you go to GTA and German gate and ask there and get a lot of disna guys input..
Also this spring could be broken
Part # 131
Honestly you go to GTA and German gate and ask there and get a lot of disna guys input..
Upvote 0
Gasram Dianas don't have T06 triggers, since the pistons are completely different between the rammers and the coilspringers (side-latching vs. latch rods), and so are the sears. Not much good have been said about the gasram triggers.
Upvote 0
I thought it was the shear due to the piston . They do say there to6
https://www.airgunsofarizona.com/gas-ram-rifles/diana-am03-stealth-n-tec-combo/
high performance Diana N-TEC gas piston
The T06 all metal trigger unit is adjustable for crisp release and length of first stage travel.
Then I guess it's lies ? Ijdk..
Also there's a pa blog thing on that spring ,ram difference with the to6 used ..
Upvote 0
Seems to suggest it's either the piston for a o5 or the piston for the o6 .
Can't swap triggers unless you also change matching piston with it .. ( bbpellter at pa blog) ..lol
Can't swap triggers unless you also change matching piston with it .. ( bbpellter at pa blog) ..lol
Upvote 0