I am studying the online pictures for some time also have WTB posts in various Forums. Not much luck getting some decent thing across the border to Canada without a long wait time and also most likely I would need to do re-machining parts afterwards to fit my Impact.
So finally I decided designing on my own something simple (and less possible moving parts) something like the Ahren's rest. A friend can machine the parts, I have plenty of time for tinkering, the winter will last at my place usually mid to late April. The other design I liked was the NOTA but stepped back from the idea - that would be again a two piece setup.
What would you change or update on that Roger Ahren's one-piece rest? Give me some new ideas.
{at this stage of a design I have elevation fine tuning range at 638mm @ 25, 1293mm @50 and 2600mm@100 meters, that is about 1.5 deg angle. I shall put there a screw with fine pitch
}
So finally I decided designing on my own something simple (and less possible moving parts) something like the Ahren's rest. A friend can machine the parts, I have plenty of time for tinkering, the winter will last at my place usually mid to late April. The other design I liked was the NOTA but stepped back from the idea - that would be again a two piece setup.
What would you change or update on that Roger Ahren's one-piece rest? Give me some new ideas.
{at this stage of a design I have elevation fine tuning range at 638mm @ 25, 1293mm @50 and 2600mm@100 meters, that is about 1.5 deg angle. I shall put there a screw with fine pitch
}
