I am fairly new to air guns. Have several but not done a lot of repairs or troubleshooting. One of our first was a DAR gen 3. Would not hold pressure and we had to eventually change regulator after the one DAR repaired did the same thing. Had been working fine till magazine got stuck. We thought it was a pellet stuck but could not get it out. It would not cock either. Took hammer spring out and piece below did not come out but seemed to be pushed down in. I was able to cock and when I put the hammer spring back in it fires about twice then will not cock again. Can't find any manual or help. Would appreciate any advice or help. Thanks Tammy
DAR DAR gen 3 not cocking
- Thread starter tammywestfall123
- Start date
Also my guess was a hammer cocking screw/pin but how do I find a part of so. Don't see any manuals anywhere.
Upvote 0
DAR Gen 3 is a sister design of the JTS Airacuda MAX and both come from same factory. 45Bravo has a series of Airacuda break-down and repair videos on YouTube, I'd suggest checking them out. WM
Upvote 0