Crown Continuum Barrel assembly question

[Mooner625]

Does anyone know how the three main parts of the barrel assembly (liner, and the two breech parts) are put together??

I was just wondering in case I wanted to change barrels at a later date.

Thanks for any information or thoughts.

Mike

 

[Rambler]

After you unscrew the shroud you will see that there is a lock nut where the liner goes into the shroud base and you will need to unscrew this to remove the liner. That done, you'll see 5 orings on the liner that need to be switched over to the new liner, and after that you can then insert the liner and tighten nut down (it won't set flush).

 

[Dairyboy]

I believe the continuum is a different barrel setup. No orings or sleeve.

 

[Long_Gun_Dallas]

There is an end cap that simply acts as a cap (doesn't touch actually barrel liner) and ldc adaptor. Glued and threaded onto the end. There is the sleeve, which has loctite and threads onto the liner receiver assembly. The liner is held into the receiver with a lock nut. Liner has 3 round plastic spacers that slip over the liner with orings on the outer edge that aligns the liner with the sleeve.

 

[Long_Gun_Dallas]

The steel and brass parts I've had no need to pull apart. Pretty sure they are threaded and loctited as well. I'd need a vice to pull those apart.

 

[Mooner625]

Thanks to everyone that tried to help.

Long_Gun hit on what I was interested in.

The brass part the steel part and the liner.

I was thinking about how much trouble it would be to to change it to a non fx- barrel

Thanks again

Mike