What is everyone with a victims using to mount a bipod? I Installed a rail on the stock but I’m not very happy with it and I’m afraid it’s going to pull out and crack the wood. I saw someone had a 3D printed clamp that went around the bottle. But can’t seem to find one for sale.
Crown bipod mount
- Thread starter freediver474
- Start date
Upvote 0
Upvote 0
I have one of the Saber bottle clamps, don't much like it. I can't say it doesn't work, but it's not as solid as a traditional rail mount. I have also read reports of adverse accuracy influence with bottle-supported rifles, although I didn't notice it. If it's for bipod use only, wood screws should not be a problem in your mounting. I generally use T nuts with machine screws for a really solid mount. If the wood is thin, you might have to cut down the height of the T nut a little, but it gives a very solid mount.
Upvote 0
Use T nuts on the crown fore end. I purchased a used crown with a rail installed from PO. Was not paying attention and BAM!! Spring loaded Bi-pod legs swung forward and ripped the rail off cracking the stock.
Upvote 0