Hey im sorta new to all of this. I have a dpms sbr and i was painting the lower receiver so I removed the trigger housing and so since there isn’t much online on how to properly remove it i was just taking out pins so when i put it back together the part that catches the hammer wont go up so the trigger doesn’t work properly anymore and i can’t figure out how to fix it.
Hello.. Swankee Setup!! Which Supp did ya use that mated to the 14mm barrel thread ?
This is like the dummy cartridge, but only has a bottom port. It would probably work with the QR mag, but I think the side port is more convienent.
Aha! Technology keeps moving forward. Thanks Fuzz