Cricket 2 pressure gauge size?

[CoyoteGod]

Been reading and trying to research but can't find the answer. Lots of information on the "special tool" to remove the pressure gauge but no information on the size. Is the gauge a 30mm or 28mm? I ordered a wiki 315 BAR 30mm from Edgunwest.com but I am not sure if it will fit inside the tube. What makes it even more confusing is I guess the special tool size to remove the gauge is 27mm? Any help would be great. I sent an email to Brian but haven't heard back yet. If you know, let me know? Thank you.

 

[Centercut]

Never heard of a 30mm Wika gauge before... They are all 28mm You need a super thin wall 27mm socket to remove those gauges...

 

[CoyoteGod]

https://www.edgunwest.com/store/airgun-accessories/item/wika-analog-gauge-315-bar/



so you can see what I purchased. Brian wasn’t sure when I emailed him. What a bummer. The 28mm wiki only run up to 250 BAR. I need 300 BAR. 

 

[B]

 27mm check out this post by @ctshooter

https://www.airgunnation.com/topic/im-no-machinist-need-help-turning-a-steel-part-to-remove-air-gauge/?view=all#post-971582

B

 

[Centercut]

Probably a misprint at EDgun West... 1 inch isn't even close to 30mm. I'm sure you got the standard 28mm Wika gauge. They just measure edge to edge and the socket or wrench would be flat to flat, so 28mm or 27mm depending how you measure... I think you ordered the correct one.

 

[CoyoteGod]

I checked Utah Airguns and they have it labeled under 250 BAR gauges, but the picture is clearly the 315 BAR gauge and it says its the 28MM. I agree I think I am good. Sent it off to Charlie so either way I will find out. LOL