I really like the setup on this the only thing I noticed is the front support is very wide and the rifle wants to cant if I'm not paying attention anyone else see this or have a fix for it.
Caldwell Deadshot Front Support?
- Thread starter brawler1588
- Start date
Turn the yoke system around, lower the wide one and raise the V shaped one. If that doesn't help you, replace the yoke
Upvote 0
My simple suggestion... find something to wrap the uprights of the front fork and just tape it on with electrical tape or the like. In the FT world. I've seen folks use everything from old cloths to small pieces of pool noodles from the dollar store. You'd need to play with sizing the 'padding' correctly.
On my FT bipod, I replaced the head with the bogpod head. But just padding it to size is much cheaper/easier as you play with sizing.
On my FT bipod, I replaced the head with the bogpod head. But just padding it to size is much cheaper/easier as you play with sizing.
Upvote 0
My change wasn't on the Caldwell Deadshot and I have no clue if you could make these work but they were better for me. I have 2 Bogpod heads and can swap them as appropriate for the rifle. Still think it's easier to pad yours out as needed.
Upvote 0
I cut 2 foam strips 3/4"x 3" (3/8" thick foam), put them on the inside of the yoke & wrapped electrical tape around them. They've held for 3 years. Helped a lot with the sloppy cant.
Upvote 0
I hate to send you in another direction but I use the Caldwell Rock Jr. Perfect for springers .
Upvote 0