Please note this was done out of pure bordem. So don't judge! This is not meant to be taken toooo seriously
sooo yeah. I was thinking awhile ago how the fittings I use for my liquid cooling loop on my Computer are "sorta" similar to 1/2 20 unf. (Computer fittings use G1/4 but looking at the the thread specs for the female end of a G1/4 the specs are realitively close in specs)
I had an old clear resivor sitting around made of some type of POM plastic.Â
Anyway it screwed right on the 1/2 20 barrel end. The material its made of is fairly flexible. So I wasn't worried about damaging the threads. But to be honest it screwed perfectly.
And since this resivor has a perfectly centered hole top and bottom. The pellet flyers through with out issue. Â
Again this was done out of bordemÂ
sooo yeah. I was thinking awhile ago how the fittings I use for my liquid cooling loop on my Computer are "sorta" similar to 1/2 20 unf. (Computer fittings use G1/4 but looking at the the thread specs for the female end of a G1/4 the specs are realitively close in specs)
I had an old clear resivor sitting around made of some type of POM plastic.Â
Anyway it screwed right on the 1/2 20 barrel end. The material its made of is fairly flexible. So I wasn't worried about damaging the threads. But to be honest it screwed perfectly.
And since this resivor has a perfectly centered hole top and bottom. The pellet flyers through with out issue.
Again this was done out of bordemÂ