i have 6 mags, and there is a variation in mag thickness, if theyre hard to push in the opening it can cause binding and misalignment .. about the only solution to that if indeed it sounds familiar, is to disassemble the mag and sand on the black pieces a wee bit to bring it down a couple thou to a nice free slip fit ..
I went back and Cleaned the Barrel made a video but it exceeds what I can Upload The only way I could put them in one hole would have to be at least 8 inches I have 2 Avengers that will stay 1/2 inch at 25 meters 27 1/ 2 yardsDid you clean barrel? My Akela barrel was filthy when I got it. Probably took 20 patches to get clean. Shoots one hole at 25yds
That is the way it came with the CrackLCURRENT80
the crack in the mag looks like one of mine that I wound up the mag than slipped out of my fingers and slammed against the pin. My bad. But if your mag is hard to wind up you can take it apart and reduce the spring pressure on it. A lot of mags have to much spring and don’t tighten the center bolt to tight or the mag will bind.
good luck
I did I loaded it with Tweezers no better I just shot 150 more the more I shoot it the better i like the AvengerHave you tried shooting without the magazine? Did the rifle come with a single shot tray?
Is the one Hole group, every one in the same Hole ? if shooting at a X one shot per X I have not been able to do thatI have an Akela, and the barrel had a very tight choke. So tight I couldn't get my cleaning jag through it. The groups were not very good. I ordered a new barrel from Crosman and it was much better. It has a tight choke too, but not nearly as tight. With the new barrel, I get one hole groups at 30 yards too.
Good luck!
Mike
I put a Barrel Band on my .22 Kratos now it shoots 14.3 Premier Hollow points as well if not better thanBenjamin New Kratos shoots all over the Place Not A clue
I took some balistol and cleaned the openings were the pellets go in, wound the mag and all is good. hope this helps.LCURRENT80
the crack in the mag looks like one of mine that I wound up the mag than slipped out of my fingers and slammed against the pin. My bad. But if your mag is hard to wind up you can take it apart and reduce the spring pressure on it. A lot of mags have to much spring and don’t tighten the center bolt to tight or the mag will bind.
good luck
Same here. Clean the barrel. Especially on a new gun. Manufacturers leaves anti-corrosion oils in there when shipping.Did you clean barrel? My Akela barrel was filthy when I got it. Probably took 20 patches to get clean. Shoots one hole at 25yds