Benjamin Marauder thumb rest install issue

I went nuclear after blowing my air stripper and baffles to chips with a double feed fiasco.
What is that bolt handle? I like!
Home made. Thank you!

There are similar aftermarket "big" bolt handles for PB rifles like my Ruger Precision Rifle. This one is called the "Hammerhead."

Hammerhead bolt handle and mag release extension.jpg


I'm surprised someone isn't making them for the Marauder.
 
  • Like
Reactions: honeysuckle
There are similar aftermarket "big" bolt handles for PB rifles like my Ruger Precision Rifle. This one is called the "Hammerhead."

View attachment 577127

I'm surprised someone isn't making them for the Marauder.
I wish I had the skills to do so. Almost every bolt needs to be bigger and levers to in my opinion
 
  • Like
Reactions: Racer88
There are similar aftermarket "big" bolt handles for PB rifles like my Ruger Precision Rifle. This one is called the "Hammerhead."

View attachment 577127

I'm surprised someone isn't making them for the Marauder.
The mrod, at least my gen 1...is a pain to do. Lots of heat for all the loctite and a lathe were involved just to prep the original bolt handle (I turned the original ball down and threaded it 1/4-28)and the stainless monstrosity is bigger than any powder burner one ive seen in 25 years of shooting. I went obnoxious on purpose because I was so pissed at double feeding and blowing up essentially all of the delrin components after the muzzle.

Its very silly proportionally. 2" long by 3/4 Dia. It is hollow tho. The disco got a longer rod and a leftover charging handle from the aea parts I used to make. I standardized all my goofy handles to 1/4 28 so I can swap them around to test.

17521577023668580408072650875450.jpg
 
So, being that I have an issue "short stroking" the bolt on my new Marauder, which annoyingly results in a failure to cock the hammer.... I purchased a thumb rest from Airgun Revisions. Seemed like it might be a help for me to more positively cycle the bolt thus avoiding the failure to cock. And a simple "mod," too.

View attachment 576215

Only problem... it doesn't fit. It appears the threaded part of the barrel sits just slightly below the cut-out in the wood stock. So, I cannot get the thumb rest to engage the threads. It won't go in straight. The wood won't allow it to align properly to engage the threads.

View attachment 576214

It would seem my choices are to grind down the wood, which is going to look like poop (hesitant to do that).... or toss the thumb rest in the garbage and consider it a fairly minor $23 mistake. :)

Unless someone here has another suggestion! Thanks!
Seems like your particular stock was an anomaly, little thicker. I got the same thumb rest mod and it fit perfectly, no modifications needed.
IMG_3561.png
IMG_3560.png
 
  • Like
Reactions: Racer88