Does anyone know a good place to purchase a fill nipple. Mines leaking really bad from the hole. Thanks
Tuning Benjamin marauder gen 2
- Thread starter rctk1
- Start date
Factory part from Crosman.
my marauder pistol I just repaired that leak. There’s a small #006 o ring on the inner check valve. Yours may be bad, or you may have some grit in there, or it just needs a coat of silicone grease. The silicone grease fixed mine, but I am prepared to change out they o ring should it continue to leak there later on
my marauder pistol I just repaired that leak. There’s a small #006 o ring on the inner check valve. Yours may be bad, or you may have some grit in there, or it just needs a coat of silicone grease. The silicone grease fixed mine, but I am prepared to change out they o ring should it continue to leak there later on
Upvote 0
Corsman would be an option, low cost and fast. You need to have part number and CC in hand when you call.
John
John
Upvote 0
SqrlHntr
Member
+1 on Bigragu’s advice.
The few times my m-rods and p-rods have leaked were also just some grit. If you need the entire assembly, Crosman for sure, Tim Hill has has them as well, among other marauder parts.
https://hillairgun.com/product/fill-adapter-assembly-for-rifle-or-pistol/
The few times my m-rods and p-rods have leaked were also just some grit. If you need the entire assembly, Crosman for sure, Tim Hill has has them as well, among other marauder parts.
https://hillairgun.com/product/fill-adapter-assembly-for-rifle-or-pistol/
Upvote 0
If under warrantee, call crosman customer service. They will most likely send you a complete fill assy.
Upvote 0
You could also try taking it apart and cleaning it out. I have had one that leaked pretty bad and all it took was a good cleaning of the check valve to get it seal up perfectly. You can reinstall it with thread tape and it will should seal up fine.
Upvote 0
I found the problem, it was the tiny o-ring in the fill port,it was hard and brittle. luckily i found a spare o-ring that fits. It came from my leshiy o-ring rebuild kit. Thanks guys for the advice.
Upvote 0