I have a Barra dual caliber airgun that is locked but will not fire. Does anyone know if a way to relieve the air pressure in the cylinder? I took the barrel off but don't want to go any further with it under pressure. Thank you for any advice or suggestions.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
Barra airgun
- Thread starter GaryE
- Start date
Don't know the Barra, but, in general, slightly loosening a pressure gauge until air just starts hissing out, then leaving it to slowly vent, is how most vent pressure, absent a release valve. Gun may still have stored pressure even if gauge says zero so firing a few times should clear that. WM
Upvote 0