- The AGN App is ready! Search "Airgun Nation" in your App store. To compliment this new tech we've assigned the "Threads" Feed & "Dark" Mode. To revert back click HERE.
Avenger Arrived
- Thread starter 30harry
- Start date
OK, for some reason I thought yours was 22 like mine. I see where I missed that it is a 25.
With my 22 I ended up with the reg set at 2,700 and the hammer spring in 3 turns. With that I'm getting right at 900fps.
Tomorrow I'm going to see if I can shoot some 100 yard groups with both the 18.13 and the 25.39 RDs with this setting.
Upvote 0
Thanks, for the info! I'm going for a pro tune with a lower extreme spread. It's been raining here the last couple of days. Out the box I'm punching same hole @ 40 yrds.with the Benjamin Domed 27.8 with average of 870 es 12 sd 2 hi 877 low 865 out of 22 shots before the rain started again. I'll just have to wait for the weather to break.
Upvote 0
Hajimoto
Member
I have completed my Strip Stak Pak for the Avenger but it will not eliminate the need for a moderator/suppressor to achieve ultra-quiet.
Because the free area between the end of the barrel muzzle and the back of the shroud cap is relatively short (3-3/32in/81mm), there is not much room for an Air Stripper and baffle stack to do their job. I have created the most surface area I could to help mitigate sound but still push that the main goal for my Strip Stak Paks is airstream conditioning. I have ALWAYS stated that sound mitigation is an awesome but secondary end result of these assemblies.
Upvote 0
Upvote 0
I have the 1st gen Marauder and the magazines don't fit. They're about 1/8" too thick. I've heard people are laying them black side down on a level surface on top of 150 grit sandpaper and getting them to work that way.
Upvote 0
I have completed my Strip Stak Pak for the Avenger but it will not eliminate the need for a moderator/suppressor to achieve ultra-quiet.
Because the free area between the end of the barrel muzzle and the back of the shroud cap is relatively short (3-3/32in/81mm), there is not much room for an Air Stripper and baffle stack to do their job. I have created the most surface area I could to help mitigate sound but still push that the main goal for my Strip Stak Paks is airstream conditioning. I have ALWAYS stated that sound mitigation is an awesome but secondary end result of these assemblies.
Yo Haj is it possible to just get the stripper?
Upvote 0