Are there any videos of a complete tear down of a classic avenge x? Can't seem to find one. I'd like to watch one before I tear into it. Thanks.
Avenge x
- Thread starter Boomer1974
- Start date
All I found a few months ago were schematics . You might contact Air venturi for any updates . Good luck to you !
Upvote 0
A picture is worth a thousand words . I use videos for tear downs a lot . My hearing is so bad I do not comprehend many words anyway ! Comprende Amigo 
Upvote 0
This is A series of 3. Not English, but helped me. . Use Google translate If needed. Like another said, the video can be interpreted without audio.
You can get the schematic at PA under the resources tab (I think that’s what the tab is called). They also sell the o-ring kit at PA.
personally, I needed one other piece of info and called the manufacturer. The person I talked to was great as well both had the schematic up and were able to reference the issue with identified parts.
Good luck. For a new rifle, all my o-rings were hard as plastic and needed cut out and replaced. Easy, once I had them.
You can get the schematic at PA under the resources tab (I think that’s what the tab is called). They also sell the o-ring kit at PA.
personally, I needed one other piece of info and called the manufacturer. The person I talked to was great as well both had the schematic up and were able to reference the issue with identified parts.
Good luck. For a new rifle, all my o-rings were hard as plastic and needed cut out and replaced. Easy, once I had them.
Upvote 0
What is the issue you are trying to solve? You may not need a full teardown. I'm the senior airgunsmith for Pyramyd Air. I was doing a large bit of the warranty and refurbishing. You are welcome to DM but if we can keep what we're doing in the thread as well that might be helpful to others.
Upvote 0
I've got to replace the regulator and just general maintenance. I just like watching videos before I tear into anything.
Upvote 0
I had the same question regarding Avenge-X Schematics or Video. Mine developed a major leak where barrel connects to receiver, any thoughts would be greatly appreciated.
Upvote 0
No pressure is held by the barrel to receiver. Has to be leaking through the valve to get to the receiver
Upvote 0
Thanks, yes, I know barrel not pressurized. I was hoping for a clue as to what would cause a major leak and is losing air as quickly as fast as trying to fill. Won't hold ANY air. I have classic tube version and not the bottle. Thanks!
Upvote 0
Sounds like the valve is leaking. It's likely the poppet leaking. If the hammer during adjuster is set heavy you'll have to cock it to fill from empty but if you've tried that is likely just the poppet itself.
Upvote 0