Ataman M2 .35 help

[Pruitt58]

I have a air leak from the barrel.The poppet came out OK but the poppet guide doesn't seem to want to budge. On the schematics it looks like 2 O rings is all that's holding it in. Does anybody know the trick to pulling out the valve guide? Its the brass part.

 

[corny]

Trying to recall as I don’t own my bullpup anymore.

They use a lot of pins through the body of the action. If I recall properly.

Is there anything on the side like pin or set screw that could be holding it in place.

Can u post the assembly drawing?

 

[Pruitt58]

Here is a picture of the schematic.

 

[Pruitt58]

Trying to recall as I don’t own my bullpup anymore.

They use a lot of pins through the body of the action. If I recall properly.

Is there anything on the side like pin or set screw that could be holding it in place.

Can u post the assembly drawing?

Thank you for the tip, I didn't think about a pin holding it in!

 

[corny]

No problem . So to it was the pin?

 

[Pruitt58]

It was as simple as knocking a pin out and installing new O rings.. Holding air like a champ . Thanks for your inspiration corny!

 

[Pruitt58]

No problem . So to it was the pin?

It was a pin, put in a new O ring. Works perfect! Thank You!

 

[Henryhudson]

Here is a picture of the schematic.

View attachment 285041

Very helpful