Arrow barrel on fx impact?

[spyde82]

Has anyone tryed putting the arrow barrel on the impact? I know the arrow has to go through the barrel suports, but will the arrow stabilizers not just go trhough them?



like on the dragonclaw where you put the arrow inside the barrel the arrow stabilizers just folds.

 

[bigHUN]

Technically possible to fabricate a threaded piece to hold the inner tube for the arrow, but my concern is calculating the air volume and power to project the arrow...you would be working with allenkeys more then shooting instead. My long range archery -thin arrows are 470 grain heavy, a crossbolt may be about 650-700 grains and about this much you would expect from air arrows as well. Anything thinner wall (to make it lighter) won't survive long especially if you shoot more arrows in a same single target.

 

[spyde82]

I think you is misunderstanding me



the fx arow barrel will fit on the impact but as it is a bulkpup gun the arow has to go trough all the barrel supprts on the impact

And i was just wundering if the arrows stabilizers would just fold when shooting them 

this is the fx arrow barrel

 

[biohazardman]

The impact does it different it uses a large diameter smoothbore barrel that fits around the arrow and special arrows with a large plastic plug seal at the back. The impact arrows have no fletching





https://www.youtube.com/watch?time_continue=11&v=a2e3iQa2Ogw&feature=emb_logo

 

[ImpactX]

 

[bigHUN]

.... I think you is misunderstanding me ....

Partially yes, sorry for misunderstanding. But what I wanted to point out, and I know archery also crossbows, you can see in the video the guy shot only one arrow in the target then go pickup and shot again and repeat this walking there and back...with only one arrow...if he would shot two (or more) of those nice looking bare shafts.. the game becomes expensive. Not a problem with the arrow tube (mounted to any airgun), but with the arrow shaft

 

[bigHUN]

Years ago I got a new Tenpoint Vapor crossbow for Field competition. This picture is I was sighting in the scope @ 90 meters, and until I finished I ended up loosing a full dozen. I am not saying it is not fun, but.... ;(

 

[Mrshosted]

Call Utah airguns they have a kit, heres a YouTube they when a deer hunt with one

https://www.youtube.com/watch?v=pS82FRum9d0

 

[CBuasri]

Old post but I've made my own impact with molded from crown setup.
Works like it should. Groups 1"-2" in groups 25yds.
Running 170 bars shoots 290-297fps with the standard FX arrows. I'm using the 30cal air port with a slug probe. Later I'll delete the probe and blanket off the end, so no probe will be needed
I'm going to down size the shaft from 10mm ID to 6mm ID which should increase the outward pressure and gain roughly 30-50 fps more.
I'm only doing this for the purpose of hunting deer during bow season..
Can't wait till deer season 2023 here we come.

 

[mtndragon]

There are videos from a few years ago of Ernest running an impact with the arrow barrel. He fletched the FX arrows with feathers and then trimmed them so they would fit through the rail support openings. He had good results.
I have the barrel kit and have it on my to do list to try it on my impact but I have been just using it on my Crown because it's easy. The arrows from the FX arrow kit are available as a bare shaft and I have a few packs for fletching with feathers as an experiment, but have not gotten around to it

fx impact arrow ernest - Google Search