I have a Tuxing compressor which is virtually new but not running (motor will not run on house's amperage). I also have a new & running YH. Are any of the internals (pistons, rods, etc.) interchangeable? Anyone have a clue or experience with this?
Are Tuxing/Yong Heng internal parts interchangeable?
- Thread starter Gerry52
- Start date
They use twist connectors, I pulled those all out and soldered mine. Fires up super strong!
I believe hawk is right about the capacitor.
I also believe the rods and 1st stage pistons are the same (though there are 87 and 89mm rod variants for just eh yong heng, so measuring would be important.
I believe the 2nd stage piston is different. But not %100
I believe hawk is right about the capacitor.
I also believe the rods and 1st stage pistons are the same (though there are 87 and 89mm rod variants for just eh yong heng, so measuring would be important.
I believe the 2nd stage piston is different. But not %100
Upvote 0
Thanks guys! When I was given the Tuxing I ordered & installed a new capacitor but with no luck getting it to run. Been sitting in my garage since then. "Wifey" getting a bit touchy about all the airgun stuff strewn about the garage. Time to find it a new & deserving home.
Upvote 0
Odoyle, yeah, I'm sure it's a 110. Just get a loud hum when turned on. Easy to rotate by hand but motor won't run.
Upvote 0