My cheaper Fastobuy has a separate o-ring on the outside of the media housing to force all HP condensate to the inside of the filter and through the 3A Molecular Sieve Desiccant Beads / cotton media. I see where the user may have water creep without any visible block on the input end?
My CS2 will pump a near tablespoon of condensate into the water trap/gap on my filter. When I open the input side, water pours out but outside plastic media tube is dry, only the first stage cotton is slightly damp, which is pulled to dry.
I ask as the Toauto, while expensive, looks to be good build quality but not sure of any water creep if you’re a user.
Filter
My CS2 will pump a near tablespoon of condensate into the water trap/gap on my filter. When I open the input side, water pours out but outside plastic media tube is dry, only the first stage cotton is slightly damp, which is pulled to dry.
I ask as the Toauto, while expensive, looks to be good build quality but not sure of any water creep if you’re a user.
Filter