Anyone have the problem with impact cf sleeve?

[BlackTulip]

My carbon fiber sleeve now stuck in the housing. 
I try all I can do but can’t move it at all. 

Anyone have idea to help me out?

 

[BlackTulip]

I tried pull or tap from inside. Nothing work. 


if like that I need to order a new sleeve which is too sad. 

 

[Vetmx]

You must have left an oring in there.

 

[Glem.Chally]

There is slight differences in some sleeves ID, we're you trying to slide it in first time? What I would do would be put the sleeve in a padded vise and put the CF in a drill chuck and try to spin it out. I was opening the ID of a CF tube with a dowel and sandpaper. It got bound up really good and had to beat the wood out of there was not easy.

A welding glove folded over is a good way to pad a vise. The rough leather gives good grabbing capability while not messing with the finish. Obviously try to clamp the area the CF is not inside of. Good luck. 

 

[Gibbs]

Try a little heat on it. The metal I think will expand and loosen a bit on the CF sleeve

 

[Glem.Chally]

Try a little heat on it. The metal I think will expand and loosen a bit on the CF sleeve

Thats a good idea, might make the epoxy on the CF greasy too.

 

[Gibbs]

Try a little heat on it. The metal I think will expand and loosen a bit on the CF sleeve

Thats a good idea, might make the epoxy on the CF greasy too.

I'm not sure I would get it hot enough to soften the CF epoxy. Go easyyyyy.

 

[Airgunmann]

Mine fit really tight I lubed the outside just a little and used all my weight to get one in then had to tap it down last little bit so the liner nut would go 

 

[BlackTulip]

It was clear nothing in there. 

 

[BlackTulip]

Yes I tried slide it in first time and it sucked right away. 
Thx a lot. I will try your way.