Tuning Anyone have a Daystate Mk4 valve wrench?

[Poopshoot55]

Resealing my mk4, I managed to get the valve out and reseal, but you have to leave the end with the oring loose to slide it back in, has pin holes in the end like a Taipan or Kalibrgun hammer spring adjuster, only it’s about 10” in the tube. Am considering making a long wooden dowel with pins pressed in or calling AOA on Monday to see if I can borrow one. Thanks Rick

 

[Hateful McNasty]

Looks like if you bought one your not just letting it go ..

Maybe make one up

A idea .

https://airgunforums.co.uk/threads/daystate-regulator-and-valve-removal-tools-question.66529/

At that day state $117 bucks I'd be ..

 

[Poopshoot55]

Will probably make one, a lot cheaper, unless AOA has one I can borrow for a slight fee.

 

[Hateful McNasty]

Will probably make one, a lot cheaper, unless AOA has one I can borrow for a slight fee.

I looked hard as I guess you did too.

Be nice if they offered a tool rental deal for this kinda thing ..


Maybe you looked at this to?

So to reassemble I had to make a tool.

https://airgunwarriors.com/community/airgun-talk/resealing-a-daystate-huntsman-classic/


Honestly I'd of figured I'd find more on that tool homemade/ diy in the forums for build ideas

 

[Poopshoot55]

Yes, did a general search, only thing that came up was a tool for alph/delta wolf. Thanks for the link to the Warriors site, maybe Chris Oldfield still has that tool.

 

[Poopshoot55]

So I found an old round garden stake, squared it off, had a couple of 1/8” dowel pins and the air tube is back together.

 

[Hateful McNasty]

Around here if it works it's good

I got / made one or two specialty
"broom handle" tools my self . Good enough to throw in a box for future use if ever needed again ...lol