Anybody use the Huma Regulator for Kral screw in version?

[kkarmical]

My valve stem broke on my puncher breaker. I have the replacement and all new orings, but since I have to open it up, why not add a regulator.

I am adding a Huma to my Mrod, and like the way it's put together, so I ordered one for the PB.

But I noticed that there is another version now where the valve endcap is removed and

the regulator then screws into the valve body.

Anyone using this yet? Just ordered today probably have a couple weeks wait for the mail being holiday season and all.

Think I'm going to polish the barrel also, its shooting good already, but why not since its apart.

 

[Yossshooter]

let us know how it works out as i would also like to put a regulator in mine

 

[kkarmical]

 

Well the great news is that it turns out not to be a broken valve stem at all. When I took the hammer out the hammer spring just somehow became coiled in a manner that it wouldn't allow for bolt to fully close.

I just assumed the worst. It was a quick fix, but Instill will install the regulator when it arrives.

 

[IraLite]

Did you order from Trenier Outdoors? I have a order in from Huma-Air, 18 days ago, just now clearing customs departing NY!

 

[kkarmical]

Did you order from Trenier Outdoors? I have a order in from Huma-Air, 18 days ago, just now clearing customs departing NY!

Mrod - Treniner Outdoors here in 3 days

Kral PB - Huma-Air Netherlands, gets here when it gets here which is fine, hey I've had the Mrod ref now for over a week, and it's still not installed

 

[kkarmical]

Ok so finally got around to installing the Huma, it was pretty easy actually.

First set reg to 115 bar after reading online, but couldn't get the fps I was after, so upped it to 130, so far so good.

Not going run full shot strings, going to shoot for a while let the regulator break in, but have the NSA 17.5 HP right at 30fpe.