Any Tips Or Tricks For Kral Knight/Nemesis

[brawler1588]

Recently picked up a kral knight/nemesis and sighted it in at 25 yards and shoots great so far but my mind is always going and wondering what I can do to make it better gauge replacement tweaks mods etc. I have the .25 and it had a real bark so added my sumo to it is the sumo a good option or should I get a different. I know its very similar to the jumbo so any info would be greatly appreciated. Should I add a regulator and a carbon bottle anything to make this my top shooter until I get the funds for a higher end. 

 

[JimNM]

Get a chronograph. use the chronograph. Don't waste time air and pellets chasing "better" if you don't know what you have. 

 

[JimNM]

25 yards is too short to test. Start at 25, but work at 50-75.

 

[brawler1588]

I have a chronograph just haven't had a chance to test yet wife is due Thursday with our second. Usually don't hunt or pest past 50 but would like to reach out if needed of course 

 

[rangur1]

I just went down this road. You could put a reg on it but it does crank out a ton of shots as is. It slowly drops power as you shoot consistently. I would use as is for a stretch . Then contemplate changes.

 

[thammer]

A few valve mods, porting and a dual spring debounce hammer will put that gun at nearly 60 shots at 60fpe with JSB MKII Heavies no regulator needed. 

 

[thammer]

https://youtu.be/p65kkhZYB9Q



The Knight uses the same valve/bottle as the Pro500. Here's what I'm getting from it. 

 

[zx10wall]

Wow Troy. You’ve got that dude dancing. Nice job. 

 

[Rich_B]

I have the same gun. Send your hammer to Troy, open the ports up, and enjoy. I did all of those and it really made a consistent and efficient rifle. Mine is .22 and it seems to like most pellets I’ve put through it when you find the velocity that they like. As a bonus, mine turned out to like the Nielsen 17.5 gr slugs also. If you want to try a regulator on it, let me know. I have a Huma that I might turn loose of.

 

[Rich_B]

And, make sure to really polish the barrel, both of mine were about as smooth as a corn cob. If you find a new gauge that will work, post it here please.

 

[brawler1588]

And, make sure to really polish the barrel, both of mine were about as smooth as a corn cob. If you find a new gauge that will work, post it here please.

Contacted a guy in the UK and he said it's a standard gauge thread so I'm thinking a wika gauge should work.

 

[property of CRS]

And, make sure to really polish the barrel, both of mine were about as smooth as a corn cob. If you find a new gauge that will work, post it here please.

how do you go about polishing the barrel?

 

[Rich_B]

I used the Wheeler bore lapping system. I only used the two finest Gris rolled into some slugs. I think I used ten slugs with each grit on them. Clean it well after and you should have a nice clean and shiny bore.