Annihilator Airguns and Tuning

Try still offers the quiet mod. It works very well.

Have you shot the gun yet? My gun is more accurate than I am. The trigger is easy to adjust and that helps with shot to shot consistentcy.



What gun?

What Cal?

What scope?

What is your shot count now and what is your group size now.?

Have you scrubbed the barrel until it shines? Is your stock tight on the action?






 
Accuracy, shot count and quiet it down. The first step would be a regulator.

I'm in the process of adding a regulator to my Kral puncher breaker, tracking says it will be here 12/31... First step is ordering the regulator. I ordered a Huma from here. It takes about 2 weeks coming from the Netherlands .

https://www.huma-air.com/Kral-Arms-Puncher-Breaker-regulator

Next use the oring list below and order all the orings needed. I use the oringstore.

https://www.theoringstore.com/store/

Then watch Troy's disassembly video and follow the instructions, going as far as removing the valve.





https://youtu.be/5s-0c50sn5E





Follow the instructions for installing regulator, then put your gun back together making sure to use a good silicone grease for the orings.

If your gun has never been disassembled you may need a heat gun for the threadlock Kral uses on the air cylinder.

1577459244_14051924245e061e2ca09b79.61599542_Screenshot_20191112-134215_Chrome.jpg

 
I just had a gun tuned by Troy not to long ago! He's had some personal stuff going on in his life. To my knowledge he's still tuning, but he's going to change his policy and only sell tuned guns. Be patient, even more now with everything going on. The Kral tune he did for me rocks! He knows what he's doing. I'll buy another gun from him even if it takes time to get it, it's worth the wait!