All Things PARD Night Vision & Thermal Optics - Master Thread

[Florida_Man]

I just downloaded it. I'll install it this afternoon thanks a lot!

The firmware is installed Now i can go to 102 but this is still about 40-50 short to get it zero on 25m. Any ideas or do i have a bad unit maybe? Or is my airgun too far off?

I run all adjustable with my Pards. Eaglevision with the 008 and Vector Optics rings with my DS35.

 

[OomJ]

For now i'll shim the rear mount and wednesday i'm going to check out the FX DRS TAC 700 as a replacement. I have taken the barrel off my Hatsan BT65 and it seems to whobble a bit on a flat surface.

 

[Florida_Man]

For now i'll shim the rear mount and wednesday i'm going to check out the FX DRS TAC 700 as a replacement. I have taken the barrel off my Hatsan BT65 and it seems to whobble a bit on a flat surface.

What caliber are you going with? I highly suggest also considering a AirMaks KATRAN

 

[OomJ]

What caliber are you going with? I highly suggest also considering a AirMaks KATRAN

I'm looking for .25

But the fx can be bought pretty cheap here in the netherlands.

I have now shimmed the rear mount with a piece of business card. I noticed the battery drain is terrible when IR is on did anyone replace the battery? Or is it wise to carry some spare batts.

 

[Ezana4CE]

…I have now shimmed the rear mount with a piece of business card. I noticed the battery drain is terrible when IR is on did anyone replace the battery? Or is it wise to carry some spare batts.

@OomJ I suggest that you carry 2 spare batteries in a plastic case. Try not to run the integrated IR light constantly. It will drain your battery faster. If you need to have the IR on for extended periods it may be wise to purchase a cheap external IR torch with a remote pressure switch. This way you don’t impede your ability to record. It’s a lot easier to me to swap batteries in an IR torch in the dark than batteries in the scope.