Has the Airforce Airguns E-Pump Compressor been used by anyone on this forum? It was launched several years ago but does not seem to have talked about.
Airforce Airguns E-Pump Compressors
- Thread starter ScottEnglish
- Start date
You might want to read the PA reviews first.
https://www.pyramydair.com/s/a/AirForce_E_Pump_Compressor_4500_PSI/8393
https://www.pyramydair.com/s/a/AirForce_E_Pump_Compressor_4500_PSI/8393
Upvote 0
G
Guest
Guest
This post is my own:
https://www.airgunnation.com/topic/catastrophic-airforce-epump-failure/
I absolutely would not consider this pump nor purchase it. It is structurally unfit for pumping at pressure. The frame flexes at pressure causing the off-centered gear rod to warp and bind against the collar. It is a motorized, slow, Chinese made, highly over priced, and under-engineered piece of rubbish.
It lacks adequate moisture filtration and simply self-detonates itself if pumping to anything above 2500 PSI. The frame flex is significant enough to cause the binding and collar popping at which point if it jams it then causes the motor to stall attempting to still work. Then it overheats and burns up.
See https://www.airgunnation.com/topic/airforce-epump-overpriced-under-performing-but-runs-off-3-2amp-12v-dc/#post-449138 as well, it is also my post.
https://www.airgunnation.com/topic/catastrophic-airforce-epump-failure/
I absolutely would not consider this pump nor purchase it. It is structurally unfit for pumping at pressure. The frame flexes at pressure causing the off-centered gear rod to warp and bind against the collar. It is a motorized, slow, Chinese made, highly over priced, and under-engineered piece of rubbish.
It lacks adequate moisture filtration and simply self-detonates itself if pumping to anything above 2500 PSI. The frame flex is significant enough to cause the binding and collar popping at which point if it jams it then causes the motor to stall attempting to still work. Then it overheats and burns up.
See https://www.airgunnation.com/topic/airforce-epump-overpriced-under-performing-but-runs-off-3-2amp-12v-dc/#post-449138 as well, it is also my post.
Upvote 0
On the other hand, I have an Airforce hand pump that has been cranking along for years. Too bad about their compressor.
Upvote 0