Anyone know the O-Ring size on an Air Venturi Jubilee Valve, 7/8 inch? Brandy Spanking new 74cf Wingman tank, filled and O-Ring blew. I've contacted PA, but does any one know the size or a decent way to figure it out?
many thanks!
many thanks!
Air Venturi Wingman Jubilee Valve - O-Ring size?
- Thread starter Saltlake58
- Start date
Have you called or emailed Air Venturi, I would give that a try. They may send you one, who knows.
Good luck to you!
Good luck to you!
Upvote 0
Contacted PA last night. Giving them a chance since they were the vendor I bought from. AV is next!
Upvote 0
The o-ring size for a 7/8-14 valve is a 116. I'd buy 90 durometer buna o-rings rather than 70 durometer if I was ordering some. Make sure your valve is tight enough to not see any of the o-ring which means no visible gap between the valve and the tank. You should only tighten it hand tight.
Upvote 0
Humdinger - thanks for getting back, but after measuring, it's closer to a 212. I have the good old Harbor Freight collection. The 116 is too small, the 212 is much closer. Thanks for getting back though, made me go look and figure it out!
Upvote 0