N/A Aigunsmithing Tools - Advice and Suggestions
- Thread starter Ezana4CE
- Start date
I got a set of the "Stubby" wrenches ..just what i needed for those tight areas
Thanks for the links
Upvote 0
I went with a Chapman set. Haven’t used it yet, but looks like good machining. There are some nice little touches to these tips.
Upvote 0
I’m liking this Work IQ vise already! I was able to use it with some soft jaw pliers and remove an end cap tightly screwed into a moderator and an adaptor screwed tightly into a moderator end cap. Both are Donny FL moderators. They can be hell to separate from end caps and adapters. This vise definitely did the trick.
Upvote 0
You need to be able to see. Buy lamps.
Many screwdrivers, Allen wrenches, pics to remove o’rings.
You need a piece of white hairy fabric, in order to be able to disassemble the rifles over it and pieces do not jump everywhere.
A rubber hammer.
Bubble levels.
All kind of tips for screwdrivers.
Silicone grease
Blue locktite
A good set of wrench
Teflon tape
Antislipery hand gloves.
Many screwdrivers, Allen wrenches, pics to remove o’rings.
You need a piece of white hairy fabric, in order to be able to disassemble the rifles over it and pieces do not jump everywhere.
A rubber hammer.
Bubble levels.
All kind of tips for screwdrivers.
Silicone grease
Blue locktite
A good set of wrench
Teflon tape
Antislipery hand gloves.
Upvote 0
Just like everyone else here I love me some tools. I have a medium sized toolbox with all the immediate items. But my gun room is my tool room as well so there's a lot in there. I just have to figure out where stuff is. I also like to use special boxes to keep things easily accessible. Great thread.
Upvote 0
I think the MOST important thing of all is a good work bench, if you don,t already have one. Best that
bench be a for air guns only. I have learned the hard way. Also stated above some good lighting. These
guns have many small screws and nuts. I always have some containers to put the fasteners into so
they do not get scattered & lost. Be leave me that can be your number one problem. JMOHOP.
Fly
bench be a for air guns only. I have learned the hard way. Also stated above some good lighting. These
guns have many small screws and nuts. I always have some containers to put the fasteners into so
they do not get scattered & lost. Be leave me that can be your number one problem. JMOHOP.
FlyUpvote 0
If you're going to make suggestions, please share specifics like brand names, links, photos, etc.
Upvote 0
Yes. scope mounting only. Bubble levels are not very precise. These are 30.00 at Home Depot or Amazon.
Upvote 0
