My brother gifted me a Yong Heng 7H-QB01 compressor that he picked up for $10 at a garage sale. I set it up and I'm not getting any pressure to build up. The steel lines heat up like I figure they should for compressing air, but after 10 minutes of running there was no change on the pressure gauge. It's not making any weird noise compared to the ones I watch on YouTube, so I was wondering if anyone had advise on what to check for on it.
7H-QB01 Yong Heng no pressure
- Thread starter TraskG
- Start date
You have a leak somewhere most likely. The sealing washer atop the cylinder on that output line is one place they may leak.
Upvote 0
Yong Heng (Model YH-QB01) should have come with test plug; garage sale might not have included. Search, "PCP test plug," on eBay, you can find a version for under $10. Does the compressor metal ID plate list YongyIheng Pneumatic Company like one pictured? If so, you've an authentic which is best for finding repair parts, if needed. WM
Upvote 0
A common place for leaks is the dowty seal (bonded metal washer) at the very top of HP cylinder where the nut of the HP metal tubing screws onto that cylinder. Also check the burst disc. In both cases soapy water spray will help determine this and BOTH are very easy fixes.
Upvote 0
I can attest to the burst disk issue, I currently have a blown one after 2 years of us on mine. 14mm wrench, EZPZ.
Upvote 0
Keep us posted as to what you find out. I am awaiting delivery of my 2nd YH after getting 3.5 years of service from my last one.
Upvote 0
Are the drain screws in tight? Being a garage sale find, maybe they aren’t even with the compressor?
Upvote 0
Good question, it DID NOT have the original screws, whoever had it used some Allen head screws. I should probably order some replacements.
Upvote 0
If the screws have been replaced you should remove them and make sure the seals are in good shape. Good chance the screws were cranked way to much.
Upvote 0