G
Guest
Guest
I need a barrel band made for my Umarex Hammer. I’d like to eliminate the shroud so I can fit a larger bottle to it. Anyone up for making one? Pm me and I can give you dimensions.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
rodjava
Member
avoulluz,
Looks like you have 156 post on AGN and i think you may be a contributing member in good standing.
I can 3d print you a barrel band for free. Only charge materials and shipping. So depending on where to ship in the U.S., probably $10. However, you will need a digital caliper to take accurate measurements.
Then you will have to settle for a possible slightly loose fit and use some tape around the barrel or shroud to tighten the fit.
Or plan for a few adjustment based on the initial fit and all done by mail.
If you were my neighbor, I could 3d print and exact fit after a few test prints.
Rod in San Francisco
Looks like you have 156 post on AGN and i think you may be a contributing member in good standing.
I can 3d print you a barrel band for free. Only charge materials and shipping. So depending on where to ship in the U.S., probably $10. However, you will need a digital caliper to take accurate measurements.
Then you will have to settle for a possible slightly loose fit and use some tape around the barrel or shroud to tighten the fit.
Or plan for a few adjustment based on the initial fit and all done by mail.
If you were my neighbor, I could 3d print and exact fit after a few test prints.
Rod in San Francisco
Upvote 0