3D printed Turret rings????

[KevinWood44]

I plan on having a few custom turret labels made but if possible I would like to be able to remove them without ruining the label. So I was thinking if they could be put around a 3D printed ring I could put the label on the ring, then just slide it on and off as needed.

I assume this would have to be custom bc turret sizes vary so much, does anyone know anyone who makes these?

I'm sure any 13yr old with a 3D printer could do it, but this kind of thing is not in my wheel house.

Thanks.

 

[stoti]

They’re a bit of money but you might consider buying a turret from Eric at Scope Werks. They’re large and so awesome!

Stoti



This is the one he made for our Golden Eagle. I pre print a bunch of labels that fit perfectly and attach with a bit of packing tape. If I need to make a new label or make a change it’s super easy!

Here’s a better picture…Blue labels for slugs, orange for pellets!

 

[timmah]

So does the turret ring fit over the existing turret dial or does it take the place of the turret dial?

 

[JungleShooter]

Yes, my question as well.

Because I'd like to pop off one turret ring and put on another in a matter of seconds as I switch from pellets to slugs.



Matthias

 

[stoti]

Yep, it slides right over the regular turret. As you can see in the picture, there is enough room on the turret that you can have both slugs and pellet yardages on the same turret so you don’t need to swap out anything. They lock down to your turret with two set screws. They come in black or silver, open or closed top. They’re very well made and if he doesn’t have one for your particular scope, he’ll have you take some measurements and he’ll make it for you in a day or two. He has them for most scopes though. They’re great turrets!

Stoti

 

[JungleShooter]

Thanks, Stoti.

I will be considering the plunge of $55....

It would be nice if these accessories were to fit my next scope, and could be switched around, but hey, we can't have it all.

Matthias

 

[KevinWood44]

They’re a bit of money but you might consider buying a turret from Eric at Scope Werks. They’re large and so awesome!

Stoti



This is the one he made for our Golden Eagle. I pre print a bunch of labels that fit perfectly and attach with a bit of packing tape. If I need to make a new label or make a change it’s super easy!

//www.w3.org/2000/svg%22%20viewBox=%220%200%20210%20140%22%3E%3C/svg%3E

Here’s a better picture…Blue labels for slugs, orange for pellets!

//www.w3.org/2000/svg%22%20viewBox=%220%200%20210%20140%22%3E%3C/svg%3E

I've never seen a pic of your up close those are pretty sick 

I played around making labels on turretlabels.com and customturretsystem.com so I figured that would be the easiest but maybe bigger turrets would be better